Skirting boards are a fantastic way to add character and style to your home. They’re also incredibly easy to install, as long as you know how. It’s not just about joining pieces of trim along the floor; other issues need looking into before you lay any boards down.
This article will be going to explain how best to join skirting boards together so they look good, last long, and don’t make too much noise when people walk on them!
Use A Nail Gun To Join The Skirting Boards
If you want to join your skirting boards quickly and easily, use a nail gun.
There are many types of nail guns available in the market today. You must pick one that matches your needs and financial situation. You should also consider how often you plan on using this tool as well as whether or not it will be used for other tasks at home (e.g., hanging pictures).
Drill Pilot Holes And Use Glue
The first step in joining skirting boards is to drill pilot holes. This will help prevent the wood from splitting when you screw it in, and it will make it easier to line up your screws. You should use a drill bit that’s just slightly smaller than what you’re using for your screws–a quarter inch (0.25″) or 3/16″ (0.1875″) should do the trick!
Next, apply wood glue between each board where they meet at 90-degree angles. Then, hold them together with clamps until the glue dries completely overnight or longer depending on how thick your boards are and how much weight they’ll bear on top of them.
Join Skirting Boards With Dowel Centers
In joining skirting boards, you need to use dowel centers. These are small plugs that have been pre-drilled with a hole for you to put your screws through. You can buy them from any DIY store in packs of 100 or more and they are very inexpensive (you will only need about 10 for each skirting board).
Use A Miter Box
A miter box is a handy tool that allows you to join two pieces of wood at an angle. It’s especially useful when you’re attaching skirting boards to the wall, but it can also be used to join two lengths of skirting boards together.
Place one piece of wood inside the miter box so that it sits flush against one end and extends out about 1/4 inch from the other end. Then place your second piece on top and check that both ends fit snugly within their corresponding slots (this will ensure they don’t slip).
Conclusion
Skirting boards are a great way to add some character and style to your home. They’re also very easy to join together, as long as you use the right tools and techniques. If you want more information about how to help with your skirting boards please contact a service today!
